|
|
|
Adhesive and Acrylic Finishes
FOAM-TITE
A polymer-modified Portland cement product specifically designed for use as an EPS foam coating and adhesive. Foam-Tite is packaged in moisture resistant bags.
STARR Glue
Adhesive for EPS Insulation Board or foam shapes to an approved substrate. Can also be used as a leveling agent.
Power Bond
Adhesive used in attaching EPS foam to plywood, chipboard, or gypsum sheathing.
Carson's PVA Bonder
A liquid plastic admixture for cementitious products, i.e., bonder for stucco, etc.
Carson's ADMIX
An acrylic modifier to improve tensile strength of Portland cement products.
Carson's Acrylic Bonder
A liquid admixture used to add tensile strength to cementitious products. Also used as a bonder for stucco.
ULTRATITE 60
Acrylic modified liquid used when extra bonding qualities are needed over concrete or masonry to improve adhesion and curing. Also increases bonding and decreases cracking in plaster.
Carson's MultiBond
Liquid formulated product designed to enhance bonding. Can be used with masonry, block, brick, clay tiles, and Portland cement products. Product is tinted to assure proper coverage, and will re-emulsify one time.
Carson's Base Primer
Enhances the performance of the finish, promotes bond strength and eliminates background color bleed through.
Acrylic Finishes
General
Information About Our Polymer Products
Carson's Acrylic Finishes are manufactured as a pure acrylic emulsion bonder, with high grade aggregates. A special proprietary additive produces an outstanding finish. Our acrylic finishes are designed for interior and exterior finish coating with a freestyle texture over a number of substrates. CC finishes can be applied by hand or sprayed on with a "hopper." Finishes are white in color and can be colored using Carson's tinting system, offering a standard palette of 30 colors.
Acrylics are shipped in five (5) gallon units.
Storage: Our Finish products should be stored in a cool, dry place, out of direct sunlight and other possible hazards. Store between 40F and 100F.
Use: Acrylic Finishes can be applied to brown-coat, stucco, one coat, masonry, and poured-in-place / tilt-up concrete.
Mixing Tips: THOROUGLY mix the finishing product before application. If using mulitple buckets, mix them all together to achieve the highest consistency in your project.
Surface Prep: Take care that all surfaces
are free of loose debris, dirt, oil, efflorescence, curing agents,
cleaning solutions, or any other foreign matter. Ensure that all surfaces
are smooth and free of any irregularities. Pressure washing, mechanical
sanding, scrapping, chipping, or sand blasting may accomplish smoothing
and cleaning of the surface. Glossy or smooth surfaces must be
roughened to ensure a proper bond.
DO NOT apply Acrylic Finishes in environments under 40F or above 100F. After application, protect the area from inclement weather for at least 48 hours to allow for best curing.